To Factory Reset your GT and restore all of its internal settings to default, please follow the steps or video below.
- Remove any existing Swiftpoint GT Bluetooth pairings to any nearby computer or device.
- Make sure your USB receiver is connected to your computer.
- Make sure your Swiftpoint GT is switched to OFF.
- While holding down the two top buttons (Front and Rear) switch the Swiftpoint GT from OFF to the ON position. Continue holding both buttons for a full 10 seconds, then release both buttons.
- Hold your Swiftpoint GT next to the USB receiver and roll the scroll wheel once every few seconds.
- The LED should give a short flash each time you move the scroll wheel. Then will give one slightly longer flash and stay off once the pairing is complete. (this should only take a few seconds)
If your GT did not automatically re-pair with its USB receiver during the process, switch it off then back on and hold it close to the receiver while you scroll the scroll-wheel. The LED should light up green in a few seconds to indicate it has been re-paired.
The reset will have also cleared any Bluetooth pairings from your GTs memory. So these will need to be re-created using the normal Bluetooth pairing procedure